Hello!
I have two questions concerning the use of POTCAR file.
1) I wish to perform calculations with rPBE functional. As written in VASP manual the xc functional is specified in the POTCAR file. But among all available POTCAR files only files with Ceperley-Alder(LDA), PW91, and PBE exist. I did not find a POTCAR with rPBE functional specified in it. So I see the only way to perform such a calculation by using a POTCAR generated for LDA and specify the variable GGA=RP in the INCAR file. But when I perform such a calculation the following message appears in the OUTCAR file:
| You enforced a specific xc-type in the INCAR file, |
| a different type was found on the POTCAR file |
| I HOPE YOU KNOW, WHAT YOU ARE DOING
So I am not sure if the way I do the calculation is correct.
The question is whether the way I do the calculations is correct?
If not, what is the rihgt way to perform the calculation with rPBE functional
2)I have seen that some new POTCAR files have been created. I mean precisely potpaw_LDA.52 and potpaw_PBE.52 . What is the difference between these files and the old versions of PAW LDA and PBE files. Which of them should be used in the calculations?
Correct use of POTCAR files
Moderators: Global Moderator, Moderator
-
- Newbie
- Posts: 3
- Joined: Mon Aug 24, 2015 9:51 am
- License Nr.: 1182
- Location: Novosibirsk, Russia
-
- Administrator
- Posts: 2921
- Joined: Tue Aug 03, 2004 8:18 am
- License Nr.: 458
Re: Correct use of POTCAR files
There are two versions of revised PBE (cf. the comparison of functionals in J.Chem.Phys.132(2010)164117.
revPBE (PRL1980(1998)890) and RPBE (PRB59(1999)7413). The installation in VASP corresponds to RPBE.
The revision is an attempt to improve the PBE functional. Therefore the correct way is to take POTPAW_PBE
and use GGA = RP . The message in OUTCAR only confirms that you are changing the xc-part of the functional
from PBE to RPBE.
POTPAW_PBE.52 is a new generation of the pseudopotential with kinetic energy density evaluated for
the use e.g. in meta-GGAs.
revPBE (PRL1980(1998)890) and RPBE (PRB59(1999)7413). The installation in VASP corresponds to RPBE.
The revision is an attempt to improve the PBE functional. Therefore the correct way is to take POTPAW_PBE
and use GGA = RP . The message in OUTCAR only confirms that you are changing the xc-part of the functional
from PBE to RPBE.
POTPAW_PBE.52 is a new generation of the pseudopotential with kinetic energy density evaluated for
the use e.g. in meta-GGAs.
-
- Newbie
- Posts: 3
- Joined: Mon Aug 24, 2015 9:51 am
- License Nr.: 1182
- Location: Novosibirsk, Russia
Re: Correct use of POTCAR files
Okay. Thank you for the detailed answer.
I will see the mentionned papers.
Perhaps I will have one or two small questions afterwards.
Thanks again.
I will see the mentionned papers.
Perhaps I will have one or two small questions afterwards.
Thanks again.