Hello everyone,
I am running a simulation. In the consideration of good accuracy on the following velocities computation, I applied automatic k-mesh to 51x51x51 points. Then, I got this error message. Everything was fine when I ran 31x31x31 k-points. Would someone please help me out?
--------------------------------------------------------------------------
mpirun noticed that process rank 26 with PID 32194 on node node101 exited on signal 9 (Killed).
--------------------------------------------------------------------------
forrtl: error (78): process killed (SIGTERM)
Image PC Routine Line Source
vasp-mkl 00000000005F8180 Unknown Unknown Unknown
vasp-mkl 000000000045F053 Unknown Unknown Unknown
vasp-mkl 0000000000444D5C Unknown Unknown Unknown
libc.so.6 000000357301ECDD Unknown Unknown Unknown
vasp-mkl 0000000000444C59 Unknown Unknown Unknown
I deeply appreciate your kind answer!
forrtl: error (78): process killed (SIGTERM)
Moderators: Global Moderator, Moderator
-
bioggg
- Newbie
- Posts: 12
- Joined: Thu Sep 05, 2013 11:54 pm
forrtl: error (78): process killed (SIGTERM)
Last edited by bioggg on Fri Sep 06, 2013 12:35 am, edited 1 time in total.
-
support_vasp
- Global Moderator
- Posts: 1817
- Joined: Mon Nov 18, 2019 11:00 am
Re: forrtl: error (78): process killed (SIGTERM)
Hi,
We're sorry that we didn’t answer your question. This does not live up to the quality of support that we aim to provide. The team has since expanded. If we can still help with your problem, please ask again in a new post, linking to this one, and we will answer as quickly as possible.
Best wishes,
VASP