Vasp 5.3.3 non collinear, arbitrary saxis direction?!
Moderators: Global Moderator, Moderator
-
- Newbie
- Posts: 1
- Joined: Sat May 11, 2013 3:01 pm
- License Nr.: 5-281
- Location: Trinity College, Dublin, Ireland
Vasp 5.3.3 non collinear, arbitrary saxis direction?!
Hi,
I have problems when assigning an arbitrary direction to saxis. Program stops after reading magnetization. However, for saxis (1,0,0) and (0,0,1) there is no problem.
I tried to make a run with and without the WAVECAR file, but the outcome is the same. According to the output WAVECAR is not read anyway.
I really can't find any additional info on this problem so any help would be appreciated!
Thanks!
Mario
I have problems when assigning an arbitrary direction to saxis. Program stops after reading magnetization. However, for saxis (1,0,0) and (0,0,1) there is no problem.
I tried to make a run with and without the WAVECAR file, but the outcome is the same. According to the output WAVECAR is not read anyway.
I really can't find any additional info on this problem so any help would be appreciated!
Thanks!
Mario
Last edited by marioST on Tue May 21, 2013 10:53 am, edited 1 time in total.
-
- Global Moderator
- Posts: 1817
- Joined: Mon Nov 18, 2019 11:00 am
Re: Vasp 5.3.3 non collinear, arbitrary saxis direction?!
Hi,
We're sorry that we didn’t answer your question. This does not live up to the quality of support that we aim to provide. The team has since expanded. If we can still help with your problem, please ask again in a new post, linking to this one, and we will answer as quickly as possible.
Best wishes,
VASP