Calculation with extra unoccupied states getting killed
Posted: Fri Jun 21, 2024 7:55 pm
I'm currently working on obtaining the dielectric response of MoS2 thin films and I am running into issues when VASP enters the main loop when calculating the additional KS orbitals on top of the ground state. As far as I can tell all of my input files are good, but when the process enters the main loop I get the following error:
= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= RANK 15 PID 3094 RUNNING AT n578
= KILLED BY SIGNAL: 9 (Killed)
Which I know means that my process is being killed on the computer end. Is there anything in my input that would cause this (memory issues?, etc etc).
I've attached my files, however, my WAVECAR is too large to attach---even when compressed. \\
= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= RANK 15 PID 3094 RUNNING AT n578
= KILLED BY SIGNAL: 9 (Killed)
Which I know means that my process is being killed on the computer end. Is there anything in my input that would cause this (memory issues?, etc etc).
I've attached my files, however, my WAVECAR is too large to attach---even when compressed. \\