Correct use of POTCAR files
Posted: Mon May 30, 2016 2:58 pm
Hello!
I have two questions concerning the use of POTCAR file.
1) I wish to perform calculations with rPBE functional. As written in VASP manual the xc functional is specified in the POTCAR file. But among all available POTCAR files only files with Ceperley-Alder(LDA), PW91, and PBE exist. I did not find a POTCAR with rPBE functional specified in it. So I see the only way to perform such a calculation by using a POTCAR generated for LDA and specify the variable GGA=RP in the INCAR file. But when I perform such a calculation the following message appears in the OUTCAR file:
| You enforced a specific xc-type in the INCAR file, |
| a different type was found on the POTCAR file |
| I HOPE YOU KNOW, WHAT YOU ARE DOING
So I am not sure if the way I do the calculation is correct.
The question is whether the way I do the calculations is correct?
If not, what is the rihgt way to perform the calculation with rPBE functional
2)I have seen that some new POTCAR files have been created. I mean precisely potpaw_LDA.52 and potpaw_PBE.52 . What is the difference between these files and the old versions of PAW LDA and PBE files. Which of them should be used in the calculations?
I have two questions concerning the use of POTCAR file.
1) I wish to perform calculations with rPBE functional. As written in VASP manual the xc functional is specified in the POTCAR file. But among all available POTCAR files only files with Ceperley-Alder(LDA), PW91, and PBE exist. I did not find a POTCAR with rPBE functional specified in it. So I see the only way to perform such a calculation by using a POTCAR generated for LDA and specify the variable GGA=RP in the INCAR file. But when I perform such a calculation the following message appears in the OUTCAR file:
| You enforced a specific xc-type in the INCAR file, |
| a different type was found on the POTCAR file |
| I HOPE YOU KNOW, WHAT YOU ARE DOING
So I am not sure if the way I do the calculation is correct.
The question is whether the way I do the calculations is correct?
If not, what is the rihgt way to perform the calculation with rPBE functional
2)I have seen that some new POTCAR files have been created. I mean precisely potpaw_LDA.52 and potpaw_PBE.52 . What is the difference between these files and the old versions of PAW LDA and PBE files. Which of them should be used in the calculations?